Picture a Saturday morning in early November at a big hardware store on Brisbane’s northside, where the smoke alarm aisle has the look of an aisle that knows something is coming. The boxed six-packs sit at eye level. A couple in their sixties are reading the back of one box out loud to each other, trying to settle whether “interconnected” means what they think it means. A man with a trolley full of garden mix stops, picks up a pack, turns it over and puts it back. Queensland’s smoke alarm laws reach their last deadline in about two months. From 1 January 2027 they cover every home in the state, including the ones nobody is selling or renting.
Cross the border and the rules change. Keep driving to Adelaide, Hobart or Darwin and they change again. Australia has eight sets of smoke alarm laws, one for each state and territory, and they disagree on power, on placement and on which date decides the rules for your house. Our position is simple. Fit interconnected photoelectric alarms in every bedroom, every hallway that joins them and every storey, wherever you live and whatever your state’s minimum happens to be. Queensland’s rule is the strictest in the country, and it is the one worth following everywhere. What follows is general information, not legal advice, and your state’s fire service has the final word on your house.
Queensland has been phasing this in for ten years, and the last phase is the biggest. The rules have applied to new and substantially renovated homes since 1 January 2017. Since 1 January 2022 they have applied to any home sold or leased. On 1 January 2027 they reach everything else: the owner-occupied house that has not changed hands in thirty years, the granny flat, the unit nobody has looked up at since the day it was built.
Every alarm has to meet four conditions.
And they have to go in particular places:
There are clearances too. On the ceiling, an alarm should sit at least 300 mm from a wall corner and from a light fitting, and at least 400 mm from an air-conditioning vent or the blades of a ceiling fan. Moving air and dead corners keep smoke away from the sensor, and these are the spots people drift towards when they are up a ladder looking for the easiest place to drill.
For a three-bedroom house that has made do with one alarm in the hallway, this usually means going from one alarm to four or five. That is the part that sends people to the hardware aisle. For plenty of homes the shopping trip is the right answer. For some it is not, and what decides it is what is already on the ceiling.
A lot of the DIY plans floating around assume any house can switch to wireless. Buy the six-pack, take the old alarms down, put the new ones up, finished by lunch. The Queensland Fire Department’s fact sheet is plain that this does not work for every house. Where a home already has hardwired alarms, the replacements have to be hardwired as well, and hardwired alarms are a job for a qualified electrician.
So a house with wired alarms cannot go fully wireless. The wired alarms stay wired, and a licensed electrician does the work on them. A 10-year battery alarm you fit yourself is legal, but only in a house that has no hardwired alarms to begin with.
It gets more involved in a house with wired alarms in the hallway and none in the bedrooms, which is common in homes built before the rules tightened. The bedrooms can take battery alarms, but only if they interconnect with the wired ones so that they all go off together. Making a battery unit talk to a hardwired system depends on compatible alarms set up correctly, which in practice means the electrician chooses the alarms and sets up the whole system, rather than leaving half of it to you.
If new cable has to be run, a good share of that work happens in the roof space, between the joists and over whatever insulation is up there.
Outside Queensland the rules are older and much less alike. Each row below was checked against that state’s or territory’s fire service or building regulator in late October 2026.
| State | What the law requires | Checked against |
|---|---|---|
| QLD | Every home by 1 January 2027. Already required in homes sold or leased since 1 January 2022, and in new or substantially renovated homes since 1 January 2017. Photoelectric, interconnected, hardwired or a non-removable 10-year battery | Queensland Fire Department |
| NSW | Every home where people sleep: at least one alarm on every level, near the bedrooms. Fire and Rescue NSW recommends one in every bedroom | Fire and Rescue NSW |
| VIC | Required in all homes since 1 August 1997. Homes built before then may use battery alarms; homes built after need 240V alarms with battery backup. Interconnected if built or largely renovated after 1 May 2014 | CFA |
| SA | Homes approved from 1 January 1995: hardwired. Older homes: replaceable battery alarms at minimum, but a new owner (any change of ownership since 1 February 1998) must fit hardwired or 10-year non-removable battery alarms within six months | Metropolitan Fire Service (regulation 76B) |
| WA | Before a home is sold, rented or hired: mains-powered, working and less than 10 years old. Battery alarms only where wiring cannot be run. Interconnected unless the building permit was applied for before 1 May 2015. Fitted by a licensed electrical contractor | Building and Energy WA |
| TAS | Hardwired in homes built since 1 August 1997; hardwired and interconnected since 1 May 2014. Every alarm in a rental must be mains-powered or run on a 10-year non-removable battery | Tasmania Fire Service |
| ACT | Compulsory. Hardwired in houses built after 1 November 1994. Multi-level homes need an alarm on each level, interconnected. Hardwired alarms must be replaced with hardwired alarms | ACT Emergency Services Agency |
| NT | Photoelectric alarms, hardwired or with a 10-year sealed lithium battery, required when a home is sold or leased. Owners may keep older alarms until they fail. Tested every 12 months | NT Government |
Two patterns run down the table. The first is that the date your home was built or approved usually decides how its alarms must be powered. Victoria and Tasmania draw the line at 1 August 1997, South Australia at 1 January 1995 and the ACT at 1 November 1994. Older homes can often keep battery alarms, while newer ones need hardwired. The second is interconnection. The national building code has required it in new homes and major renovations since 1 May 2014, and Western Australia applies it where the building permit was applied for from 1 May 2015. A house older than that may be perfectly legal with alarms that sound one at a time.
New South Wales shows the gap between law and advice most clearly. The law asks for an alarm on every level near the bedrooms, while Fire and Rescue NSW recommends one in every bedroom. Something similar turns up in nearly every state. The fire services agree on what a safe house looks like far more closely than the laws do, and what they describe is close to Queensland’s rule.
Renting and selling are where most states tighten up. In Queensland, any home sold or leased since 1 January 2022 has already had to meet the full standard, so a rental should be compliant now. A common belief among landlords is that compliance means hardwiring. It does not. A non-removable 10-year battery alarm is allowed, unless the property already has hardwired alarms, in which case the hardwired rule applies to rentals as well.
Testing is split between the two sides of a Queensland tenancy, and this is where some guides go wrong. Under the Residential Tenancies Authority’s rules, the owner tests the alarms within 30 days before a tenancy starts or is renewed. During the tenancy, the tenant tests and cleans them at least once every 12 months. One widely read guide puts the yearly job on the owner. The RTA puts it on the tenant, and the RTA is the authority.
In New South Wales, landlords must keep alarms working, repair or replace a faulty one within two business days, check them every year and replace them within 10 years. Tasmania requires every alarm in a rental to be mains-powered or to run on a 10-year non-removable battery. Western Australia and the Northern Territory both use the sale or lease of a home as the point where alarms must come up to standard. If a property manager looks after your rental, ask which of these checks they carry out and when, and get the answer in writing.
Price is where opinion splits. A common view online is that the wireless 10-year packs are cheap enough, and easy enough to fit, that nobody needs a tradesperson. For some houses that holds. For others there is no DIY route at all. The two homes below are hypothetical, set up to show how the rules land on a real ceiling.
The prices: a Queensland price guide puts supply and installation by an electrician at $100 to $250 per alarm, plus a call-out fee of $50 to $150 (prices as at October 2026). A six-pack of wireless interconnected 10-year photoelectric alarms was listed at $265 by a national hardware chain on 30 October 2026, which is about $44 an alarm.
House A (hypothetical). A lowset house with three bedrooms off one hallway and no hardwired alarms. It needs four alarms: one in each bedroom and one in the hallway.
| House A | The sum | Total |
|---|---|---|
| Fitted yourself | One six-pack at $265 | $265, with two spares |
| Fitted by an electrician | 4 x $100 to $250, plus a $50 to $150 call-out | $450 to $1,150 |
House B (hypothetical). A two-storey townhouse with three bedrooms upstairs and two existing hardwired alarms, one in the upstairs hallway and one downstairs. It needs five alarms: three bedrooms, the upstairs hallway and the ground floor. The two wired alarms must stay wired, and the bedroom alarms have to interconnect with them.
| House B | The sum | Total |
|---|---|---|
| Fitted by an electrician | 5 x $100 to $250, plus a $50 to $150 call-out | $550 to $1,400 |
| Fitted yourself | Not an option | None |
House A can comply for a few hundred dollars and an afternoon on a ladder. House B cannot be done by its owner at all, because the wired alarms belong to an electrician and the bedroom alarms have to join them. Before buying anything, then, look up. If you are not sure whether an existing alarm is hardwired, an electrician can tell you, and it is better to know before the six-pack is in the boot.
For any hardwired work, the person on the ladder has to be a licensed electrician. Ask for the licence number and check it on your state’s licence register before you book. The directory’s electrician listings are a reasonable place to start, and some alarm and safety system installers hold an electrical licence as well, which is worth asking about.
Then ask for five things.
Buyers, selling agents and property managers often ask for a compliance certificate when a house changes hands or goes up for rent. A written record from the installer makes that conversation a short one, whatever the rules for your particular house ask of you.
Two more things are worth raising before work starts. A frequent complaint online is false alarms, from cheap units, from humidity and from shower steam. The complaint is fair. An alarm that goes off every time someone makes toast tends to come down and stay down. Keep alarms out of kitchens and bathrooms. Queensland’s location rules ask for bedrooms, hallways and storeys, not the rooms where the steam is. And if the house has raked or high ceilings, ask whether the alarms can be tested and hushed with a remote, so that quietening one does not mean dragging the ladder in from the shed.
A minority view online calls Queensland’s rules a cash grab, and a bill like House B’s can feel that way when it lands. The fire services’ advice points the other way. Across the states, they lean towards photoelectric alarms in the rooms where people sleep and along the way out, interconnected wherever possible, whether or not their state’s law requires it yet. Queensland has simply written that advice into law.
So follow it, wherever you live. Count the bedrooms, the hallways and the storeys. Check what is already on the ceiling before you buy anything, and if any of it is wired, call an electrician first. Then choose alarms good enough, and place them carefully enough, that nobody in the house is ever tempted to take one down.
Sources: Queensland Fire Department, Smoke Alarm Reforms (https://www.fire.qld.gov.au/about-us/corporate-knowledge-centre/qfdlegislation/smoke-alarm-reforms); Fire and Rescue NSW, Smoke alarms: what is the law? (https://www.fire.nsw.gov.au/page.php?id=439); Building and Energy WA, Smoke alarm laws for homes being sold, rented and hired (https://www.wa.gov.au/organisation/building-and-energy/smoke-alarm-laws-homes-being-sold-rented-and-hired)